Carbide Pin - 60° Tip angle, Standard Length STD We highly recommend the magnetic

We highly recommend the magnetic foot base in applications where the job surface is flat

Tip life depends the hardness of material you are marking

Standard Length: 72mm (standard is 52mm)

allowing easier access to the workpiece where the foot would otherwise obstruct access

Carbide Pin - 60° Tip angle, Standard Length STD We highly recommend the magneticCarbide stylus pin with a 60 tip angle Standard Length: 72mm (standard is 52mm) Carbide hardness: HRA92 Can mark metal surfaces up to 62HRC, Suitable for most Plastics This pin angle is suitable for plastics. The deformation point of plastics is much higher than metal so a sharper tip angle allows for this to be overcome much more easily without having to increase the force, which can cause an overly wide mark. You can regrind the tip or we can offer