Electronics assembly technology. Selection guidance of environmental and endurance test methods for solder joints Ingestion-build-115288 BS EN 1992-3 is the

BS EN 1992-3 is the third part of the BS EN 1992 multi-series that discusses the design of concrete structures

• Hydrogen-embrittlement-relief heat treatments

sections and bright products of standard grades and special grades of corrosion resisting stainless steels for general purposes

Values for additional space requirements are given in annex A

Electronics assembly technology. Selection guidance of environmental and endurance test methods for solder joints Ingestion-build-115288 BS EN 1992-3 is theDD IEC PAS 62137 3: 2009 describes the selection of an appropriate test method for reliability testing of solder joints. The test methods given are applicable to evaluate the strength of joints of a component mounted on printed wiring board, but not to test the mechanical strength of components themselves. The test conditions for accelerated tests (rapid temperature change and high temperature tests) may exceed the maximum allowable temperature range