Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit ISO/IEC 24570 and ISO/IEC 29881

ISO/IEC 24570 and ISO/IEC 29881

Comments should be sent in writing to the Secretary of BSI Subcommittee CH/210/3

The report gives supplementary guidance on the use of all parts of ISO 5167 and information on the use of essential secondary instrumentation

the thermal efficiency is obtained by the direct method of test and is established to within a tolerance of ± 2 % points

Cutter arbors with parallel key and tenon drive - Dimensions and designation of tool holders with 7/24 taper without automatic tool changer included-in-kit ISO/IEC 24570 and ISO/IEC 298811 Scope This part of ISO 10649 specifies the dimensions of cutter arbors with parallel key and tenon drive with 7 24 tapers without automatic tool changers.