Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Test methods to prove the design of cemented or wrapped joints Ingestion-build-115288 The recommendations are applicable to

The recommendations are applicable to loadbearing wall and partition constructions where actual stud sizes are not less than 62mm x 37mm (depth x breadth) and to non-loadbearing wall and partition constructions where the actual stud sizes are not less than 48mm x 37mm (depth x breadth)

and humidity all contribute to the ageing process

The uniform and consistent use of terms and definitions can be particularly helpful in the design process

including combined transport (e

Glass-reinforced thermosetting plastics (GRP) pipes and fittings. Test methods to prove the design of cemented or wrapped joints Ingestion-build-115288 The recommendations are applicable to1 Scope This document specifies methods of test for cemented or wrapped joints for buried and above ground glass reinforced thermosetting plastics (GRP) piping systems. This document is only applicable to the joint and covers methods of test to prove its design. It assumes that the joint either is or is not intended to be subject to the effects of hydrostatic end thrust. The tests detailed in 9. 2, 9. 4 to 9. 6 inclusive are applicable to cemented or